Weider WEBE2496 Bedienungsanleitung Seite 6

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 16
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 5
6
1.
Insert two M8 x 70mm Carriage Bolts (37) up
through the Bench Stabilizer (3). Attach a
Small Plate (12) to the Bench Stabilizer with
two M4 x 15mm Screws (46). Attach the other
Small Plate (12) to the Bench Stabilizer in the
same manner.
1
Before beginning assembly, make sure
you understand the information in the
box above. For help identifying small
parts, see page 5.
12
37
3
12
Warning
Decal
46
To hire an authorized service technician to
assemble the weight bench, call toll-free
1-800-445-2480.
Before beginning assembly, carefully read the
following information and instructions:
Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
T
ighten all parts as you assemble them, unless
instructed to do otherwise.
As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
Assembly requires two people.
For help identifying small parts, use the PART
IDENTIFICATION CHART.
The included hex key , grease packet, and the
following tools (not included) are required for
assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
clear tape or masking tape.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by almost anyone. However, the weight
bench has many parts and the assembly
process will take time. By setting aside plenty of
time, assembly will go smoothly.
ASSEMBLY
2. Attach the Bench Frame (4) to the Bench
Stabilizer (3) with the M8 x 70mm Carriage
Bolts (37) and two M8 Nylon Locknuts (43).
Do not tighten the Nylon Locknuts yet.
43
37
43
4
3
2
Seitenansicht 5
1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare